This online shop is using cookies to give you the best shopping experience. Thereby for example the session information or language setting are stored on your computer. Without cookies the range of the online shop's functionality is limited. If you do not agree, please click here. x

Countersunk head, square shank copper nail Ø 2.7 mm L : 44 mm - Ø 2.7 mm


Countersunk head, square shank copper nail Ø 2.7 mm L : 44 mm - Ø 2.7 mm

Item #: 354 70 270 044b
Reset selection L : 44 mm - Ø 2.7 mm
Product available, shipping within 48 hours Weight: 1 kg



Diameter of the shank: 2.7 mm 
Lenght of the nail: 32, 38, 44, 50, 62 or 65 mm 
Diameter of the head: 6.5 mm 
Head: diamant 

Nails are sold by boxes of 1 kg. 

Riveting technique: installation of square copper nails and their cups:

1. Pre-drill the wood with a diameter slightly smaller than the nail diameter.

2. Completely drive in the square nail, ensuring it protrudes out the other side.

3. Place the counter-rivet cup on the point and hammer it in with a setting tool, hole side, so the nail passes through it.

4. Once the cup is fully seated, trim the excess, leaving a small length equivalent to the nail's section size.

5. To properly set the rivet, compress its head to prevent it from protruding, then hammer on the part sticking out of the cup on the opposite side.

6. Initially, lightly hammer the rivet to warm the copper, then strike it with the hemispherical part of the setting tool to solidify the assembly.

Customers who bought this product also bought:

Write Product Review

You have to be logged in to write a review.
No review available for this item.